HomeProducts45 Degree Tester
45 Degree Flammability Tester, 45 Degree Tester, 45 Degree Flammability Tester, Fire-retardant Performance Tester, KS F 2819
45 Degree is used to evaluate compliance of fire-retardant products with fire-retardant performance standards according to the combustion method, and measures combustion characteristics such as After Glow and After Flame of test specimen installed at a 45-degree angle.
FESTEC 45¢ª Flammability tests After Flame Time and After Glow Time of specimen by heat in the chamber.
This measures flame retardance about specimen of less than 5 mm thick (Board, Plate, Sheet, Film and so on) by 45¢ª Micro and Airmix method and evaluates materials about 3rd grade of flame retardance (less than 15cm and 5 seconds)

   
• KS F 2819 : Testing Method For Incombustibility Of Thin Materials    (Testing Method for incombustibility of thin materials for construction)
• ASTM D 1230 Canadian Minimum Flammability Standards for most fabrics
• NFPA 702 Forced edge ignition of fabrics cited by California for Hospital Apparel and Bedding Fabrics
• CA TB 117 (2000) Upholstery Fabrics (Section E) Synthetic Filling (Section C)
• BIFMA Upholstery material screening test
¨ç Chamber shall be made in Stainless Steel. Door shall be equipped with clear plastic panel.
¨è Some combustible gaseous materials respond with or are absorbed in the wall of Chamber. Constituents of Chamber shall have minimal level of these materials. If transparency is required, Polypropylene including Polycarbonate shall be applied.
¨é Grade 1 (below 5 Cm, no residual flame)
¨ê Grade 2 (below 10 Cm, residual flame remains just within 5 seconds)
Specification
Size 730 (w) ¡¿ 250 (D) ¡¿ 900 (H)
Power 220 V AC, 60 Hz, 10 A
Weight 50 kg
Utilities LPG
¨ç Power Switch to supply or block power
¨è After Flame Time: Counter displaying After Glow time
¨é After Glow Time: Counter displaying After Flame time
¨ê Flame Spread time: Set time that a specimen catches fire (Flame Spread time)
¨ë Start Switch for starting test
¨ì Reset Switch to set Counter to ¡°0¡±
¨í Burner Selection Switch for displaying whether Air Mix Burner or Micro / Meckel Burner is selected
¨î Selection Switch to check size of fire and features of specimen in Calibration Mode and convert into Test Mode for performing test
¨ï Pressure Gauge displaying pressure
¨ð After Flame Stop Switch for stopping After Glow time
¨ñ After Glow Stop Switch for stopping After Flame time
¨ò Control Valve for adjusting pressure of Air Mix Burner
¨ó Control Valve for adjusting flame of Micro / Meckel Burner
• Specimen name and conditions
• Incombustibility type, pre-treatment method and heating time of test object
• Char length, residual flame, residual dust, and remarkable observations in terms of fire-retardant performance
• Test date, test laboratory, and test manager name